How to Add, Delete, and Modify a User from the DS7400 Series Panel Keypad

Issue

How can a code be deleted on the DS7400xi panels?

Solution

Use the following steps to change a passcode:

1. Enter the master code, and press [#], [0].
2. Press [0].
3. Enter the user number (001 to 090) (001-200 version 4 only).
4. Enter the authority lever (0 – 6). See below.
5. Enter the area the user has access to (1- 8), or press [#] for all areas.
6. Enter the new PIN. The new PIN must be four digits long.
7. Enter the new PIN again, and then press [#].

Authority Levels

• 0 = Master Code
• 1 = Unlimited
• 2 = General
• 3 = Arm Only
• 4 = Temporary
• 5 = Duress
• 6 = Access Code

To Delete a User Select the User Slot followed by the # key.

*Note: User 001 cannot be deleted in this manner, it must be changed in programmers mode.

Part numbers DS7400X, DS7400, DS7400Xi, DS7400XIVER2, DS7400XIVER3+, DS7400XIVER4, DS7447