Skip to main content

How to correct the D1260 keypad display: 'Incorrect Panel' that displays when properly programmed.

  • The D1260 Command Center will display "Incorrect Panel" regardless of proper programming when using old firmware. 
  • Replace the firmware EEProm chip with the current version 1.04 USING part number: R19-D1260-0104.
  • Note: The D1260 only operates as address 1-8, addresses 9-16 are not available.

     

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close