Skip to main content

How to disable reporting on a D4412/6412

Perform the following procedure to disable reporting on a D4412 or D6412:
  1. At the control panel, lock down the installers switch.
  2. From the keypad, press Cmd 41 and then enter the installer's passcode.
  3. Press 8 for keypad programming.
  4. Press 0221 Cmd.
  5. Press 0 and then the star key (*).
  6. Press and hold the Cmd key to exit programming.
  7. Unlock the installer's switch.
  8. In RPS, go to Global Reporting Options and then set Enable Reporting to No.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close