Skip to main content

How to interpret System Troubles with the D621 Keypad.

  • 1.  Ensure the area is disarmed.
  • 2.  Press Cmd + 4 + 2.  The flashing Cmd light is a prompt to enter a valid passcode. 
  • 3.  Enter a valid passcode and the D621 displays system trouble events by lighting the point indicators (zone leds)as described below:
  •  Zone 1 Lit steady = Telephone line Fail
  •  Zone 1 Slow Flash = Comm Fail, Destination 1
  •  Zone 1 Fast Flash = Comm Fail, Destination 2
  •  Zone 2 Lit steady = Alternate Comm Trouble
  •  Zone 3 Lit steady = Installer Switch Closed
  •  Zone 4 Lit steady = Backup Battery low
  •  Zone 4 Lit steady = Slow Flash = Backup Battery Missing
  •  Zone 5 Lit steady = Bell Supervision Fail
  •  Zone 6 Lit steady = RF Receiver Jamming
  •  Zone 6 Slow Flash = RF Receiver Trouble
  •  Zone 7 Lit steady = Data Bus Device Missing
  •  Zone 7 Slow Flash = Data Bus Device Tamper
  •  Zone 7 Fast Flash = Data Buss Device Trouble/Reset
  •  Zone 8 Lit steady = System Fault
  •  Zone 8 Slow Flash = Service Interval
  •  Zone 8 Fast Flash = Ground Fault Condition
Press Cmd to return to the off state.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close