How to program network reporting in a GV3 Version 8.00-8.09 control panel.

Configure for network reporting in version 8.00-8.09 GV3 panels as described below.

Panel Wide Parameters > Routing.
- For selecting which of the 4 paths the primary or alternate device will use for network communications.
Enhanced Routing.
- For selecting a network device addressed as SDI88 or SDI92 to use for network communications.
GV2AUX > Enhanced Communications.
- For entering the address, supervision and configuration settings for the reporting receiver.
GV2AUX > Route Group Parameters.
- For configuring the route group to report to a single receiver or multiple receivers.

1. Panel Wide Parameters > Routing:
Access Panel Wide Parameters and Routing. Enter the number of the network path (1-4) to be used for network communications.

GV3 Lower Routing.png

2. Panel Wide Parameters > Enhanced Routing:
Select Yes for the physical address of the network communicator; SDI88 or SDI 92. Phone communications are used when No is selected for all options programs in a particular route group.

GV3 Lower Enhanced Routing.png

3. GV2AUX Enhanced Communications:
Select Enable Enhanced Communication=Yes to enable network communications. Select Yes for Anti-Replay. Enter the IP address and Port number of the network receiver.

GV3 Lower Enhanced Communications.png

Set the supervision interval by entering the Poll Rate, ACK Wait Time and Retry Count using the formula below. The above example displays settings for 300 second supervision.

Supervision Interval	Poll Rate	Ack Wait	Retry Count
90 Seconds: UL 1610	60	5	5
200 Seconds: UL 1610	110	15	5
300 Seconds: NFPA 72 2010	210	15	5
1 Hour: NFPA 72 2013	3240	60	5
4 Hours	12600	300	5
24 hours – Daily	64800	3600	5

4. Route Group Parameters.

When both Primary and Backup paths point to the same receiver:
- Set RG x Same Network Receiver=YES.
When Primary and Backup paths point to different receivers:
- Set RG x Same Network Receiver=NO.