How to program RF Points into 2000 Series control panels.

RF Programming is available in D2212B, D2412U and D2812 panel types.
A D208RF or D216RF Receiver is required for RF points.
It is possible to encounter RF receiver errors when attempting these operations. An example would be programming the point code for Point 10 as an RF point using a receiver on address 8, when there is no receiver connected to address 8. When you attempt to add Point 10, the system is unable to communicate to a receiver. In this event, you will see the display:
- NO REPLY RCVR 8
- PRESS CLEAR
After pressing [Clear], the display returns to the RF menu.

Close the installer pin on the panel
Press 1 at the keypad, the keypad displays: [ENTER CODE TO START TEST]
Enter the installer pin (default 654).
Press the [4] key to display the RF programming menu.
The display scrolls the three RF menu options:
1. TO ADD POINTS PRESS 1
2. TO TEST POINTS PRESS 2
3. TO REMOVE POINTS PRESS 3
To exit the RF Programming menu and return to the diagnostics menu, press the [Clear] key.

Adding RF Points

Adding RF Points does not apply to “E” version panels. To add a point, you must have previously given it an RF point code (digits 4 and 5).
1. In the RF menu, press [1] to Add Points. If there are points yet to be added whose point codes have been programmed as RF, the keypad displays the first one to be added (in this example, Point 1 is the first point programmed as an RF point):
ADD POINT 1

PRESS *

To scroll the remaining RF points, press the [C] key repeatedly. If there is only one RF point, it will continually re-display. If there are no points programmed as RF points, or if all programmed points have already been added, the display shows the following.

NO PTS TO ADD!
PRESS CLEAR

After pressing the [Clear] key, the system returns to the RF menu.
1. Press the [*] key to select the point displayed. The display shows:
  
  ACTIVATE
  POINT 1
2. Press the tamper switch on the sensor you want to add as Point 1. When the transmission is received ,the point is added and the display shows:
  
  POINT 1 ADDED
  PRESS CLEAR
  
  If the sensor was added into some other point, or two points were inadvertently programmed to the same sensor loop, the display shows the following (in this example, the sensor was previously added as Point 2,although it could be any point number):
  
  DUPLICATES PT 2
  PRESS CLEAR
  
  Press the [Clear] key and repeat the procedure using a sensor that was not already added, or check point programming to confirm that two points were not assigned to the same location (see digit 4 and 5 of point code).
3. Pressing the [Clear] key returns the display to the next RF point to be added:
  
  ADD POINT 2
  PRESS *
4. Pressing the [Clear] key again returns the display to the RF menu.