How to Program the D9112B and D9112B1 to Send Restaorals

Panel is not sending restorals when the point restores.  Log also has no entries for restorals on the point.

 

 

This is normal if the panel is programmed not to send restorals.

In RAM/RPS check in the following:

Point Index Codes > Point Indexes 1-16 or Point Indexes 17-31

Disable Restorals

Default: No    Selections: Yes or No

Yes: Disable restoral reports for this point.
No: Enable restoral reports for this point. When this option is enabled, a restoral report is sent to the receiver when the point returns to normal after being in an alarm or trouble condition.

If you are using the 5200:

In the 5200 check under:

• 9112B > Point Index > Point Index # (where # is a value between 1 and 31 only)
• press the white ENTER key
• press the down arrow key (red keys on the 5200)
• Repeat until you are at P## Disable Restorals

Default: No
Selection: Yes or No
Yes = Disable Restoralreports for this point.
No =  Enable Restoralreports for this point.

When this option is enabled, a Restoral report is sent to the receiver when the point returns to normal after being in an alarm or trouble condition. Use this item to automatically put this point back into the system.