How to properly use T-tapping with MUX devices with the D8125MUX.
Is T-tapping acceptable when using MUX devices on the D8125MUX?
Use one two-wire data expansion loop using MUX BUS A, or distribute the devices on both MUX BUS A and B. Determine the required wire gauge for each MUX bus expansion loop. Programming the individual multiplex points with the D5060 Multiplex Point Programmer assigns them to point numbers. Daisy Chain and T-tapping configurations are acceptable.
JavaScript errors detected
Please note, these errors can depend on your browser setup.
If this problem persists, please contact our support.
