Skip to main content

Troubleshoot B426: heartbeat LED is off

Causes:

 

The heartbeat LED on the B426 is off.

No communication failure, trouble or communication module missing error messages at the keypad.

 

Solution

 

Check the TMPR pins next to the Ethernet port on the B426.

Troubleshoot B426  heartbeat LED is off.png

Remove the jumper from the pins; the B426s heartbeat LED will start flashing to show the firmware version on the board and then it will resume normal or trouble operation depending on the condition on the B426.

When the Tamper jumper is covering both pins the heartbeat LED is turned off to save power.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.