FAQ: CGI commands to enable or disable the wiper of MIC 7100i, 7000i, fusion 9000i

Question

Which are the CGI commands to enable or disable the MIC 7100i/MIC 7000i/MIC fusion 9000i camera's Wiper?

Answer

Firmware v7.84.0023 and above

• Function : Disable Wiper during operation
  This command is persistent through reboots and power cycles.  The wiper is re-enabled if a system restore or factory default is performed on the camera.

CGI command :

http://<IPAddress>/rcp.xml?command=0x09A5&type=P_OCTET&direction=WRITE&num=1&payload=0x800004024c030000

• Function : Enable Wiper during operation

CGI command :

http://<IPAddress>/rcp.xml?command=0x09A5&type=P_OCTET&direction=WRITE&num=1&payload=0x800004024c030001

Firmware v7.70.0126 and v7.72.0

• Function : Disable Wiper during boot-up

CGI command :

http://<IPAddress>/rcp.xml?command=0x09A5&type=P_OCTET&direction=WRITE&num=1&payload=0x80000203a0020000

• Function : Enable Wiper during boot-up

CGI command :

http://<IPAddress>/rcp.xml?command=0x09A5&type=P_OCTET&direction=WRITE&num=1&payload=0x80000203a0020001

Firmware v7.80.0127 and above

• Function : Disable Wiper during boot-up

CGI command :

http://<IPAddress>/rcp.xml?command=0x09A5&type=P_OCTET&direction=WRITE&num=1&payload=0x8000040249030000

• Function : Enable Wiper during boot-up

CGI command :

http://<IPAddress>/rcp.xml?command=0x09A5&type=P_OCTET&direction=WRITE&num=1&payload=0x8000040249030001