How to configure the SNMPv3 traps on VJD-75xx?
General information:
Since FW 10.40.0055, SNMPv3 traps have been included for the Videojet Decoder 75xx
SNMPv1 is not supported by the decoders
3 traps are supported:
Processor overload - 1.3.6.1.4.1.3967.7.3.1.1
Memory overload - 1.3.6.1.4.1.3967.7.3.1.2
Thermal overload - 1.3.6.1.4.1.3967.7.3.1.3
MIB file: BOSCH-VJD_SNMPv3.mib
What is the VideoJet VJD-75xx SNMP get/set port:
VJD-75xx don't offer a SNMP server which answers to incoming SNMP get or set requests, they only send traps when an overload situation starts and ends.
Step-by-step guide
Configuring SMNPv3:
Open CM or BVMS CC and select the VJD's
Navigate to Network- Network Management.
Select SNMPv3
Enter SNMP Host address - up to 2 supported host addresses
Enter Trap User username
Set Authentication protocol to SHA1, MD5 or None
Note: ensure the trap receiver accepts encrypted traps and other auth modes than SHA1.
Enter Authentication password
Set Privacy protocol to AES, DES or None.
Save
Known restriction:
Overload messages and traps may appear too sensitive in cases where display refresh rates are lower than video stream frame rates.