AEC1.0 – Elevator Control
Install AEC – 8I8O – EXT board
-
Follow directions in the AEC Installation Manual to attach and properly address the AEC-8I8O-EXT board.
Program the AEC controller through the Access Easy web interface
-
Connect and log into the configuration web page for your panel.
-
Output Setup
This section will be used to name the relay outputs on the AEC-8I8O-EXT.
Outputs 1 to 8 will be on the output board addressed as number one by the on-board jumpers. Outputs 9 16 on output board number 2, etc.
-
Card Readers
This section will allow you to select a reader as an elevator reader and link it to the appropriate outputs.
-
Access Groups
In this section, you will give an access level permission to access assigned floors.
-
Card Assignment
This section will allow you to assign an elevator access group to a card holder.
-
Test the System