-
Program the D8229 with a facility code or leave the default at 0 using the instructions provided with the Keypad.
-
Wire the D8229 to the 1300 or 1320 module using the installation instructions provided with the Keypad.
-
In rdkypro go to "sys admin" under "administration" and select "card formats".
-
Create a 26bit card format or modify the existing one and enter the facility code programmed into the Keypad.
-
Under "administration" select "cardholders". Create a cardholder in the appropriate tabs. When selecting the "badge" tab, in the "badge id" and enter the four digit code that the user wishes to use.
-
Log off and then back on to " sys admin".