6026 How to access keypad programming the GV3 Panel.

Keypad programming is available in GV3 panels with firmware revision 8.10 or higher. 

NOTE: Keypad programming is not available during while an RPS programming session is active, or when any area is armed.

Enter from normal operation:

1. Press [9]+[9]+[Enter].

2. Select Keypad Programming. The keypad displays Enter Passcode.

3. Enter the service passcode (default= 123).

Enter from service mode (reset pin closed):

1. D1255: Set the address to 16 with dipswitch: 1-5= OFF and 6= ON. The keypad displays Enter Passcode when the reset pin is closed. Enter the service passcode (default= 123).

2. D1260: Set the address to 8 with dipswitch: 1-3= OFF and 4-6= ON. The keypad displays Enter Passcode when the reset pin is closed. Enter the service passcode (default= 123).

The following options are available upon entering keypad programming:

• Phone Numbers – Phone 1 thru Phone 4 Phone Format - Phone 1 thru Phone 4 Enhanced Comm – Path 1 thru 4

• Routing Route Groups 1 thru 4

• RPS Parameters RPS Passcode RPS Phone Number RPS IP Address RPS IP Port

• Area Parameter – 1 thru 32 Account On – Yes / No Account Number

• Command Center 1 thru 16 Enhanced Command Center – Yes / No Command Center Scope –

• User Pass Code User 0 (Install Passcode) User 1 (User Passcode)

• Point Parameters D9412GV3: 1-247 D7412GV3: 1-75 D7212GV3 1 -40 Point Index

• Disable Keypad Programming