How to enable the ground fault on the D9412G and the D7412G

 Look on the left side of the panel for the Ground Fault detect latch pin. This pin looks like half of a safety pin. It should be in the latched position. After ensureing the ground fault is in the latched position, enable ground fault detection in the panel program.

1. Go to the MAIN part of the program,

2. Go to RELAY PARAMETERS

3. Go to AREA WIDE RELAY

4. Go to SILENT ALARM. Put anything but a zero in this location to enable ground fault detection.

1. Look on the left side of the panel for the Ground Fault detect latch pin. This pin looks like half of a safety pin.  It should be in the latched position.

2. After ensureing the ground fault is in the latched position, enable ground fault detection in the panel program.

3. Go to the MAIN part of the program,

4. Go to RELAY PARAMETERS

5. Go to AREA WIDE RELAY

6. Go to SILENT ALARM. Put anything but a zero in this location to enable ground fault detection.