-
The D4412 and D6412 use the D621, D623 or D625 command centers. Pressing All-On or Part-On on the will arm only the area where the keypad is assigned.
-
Command 50 may be used to move to an area other than the programmed assigned area. After moving to the selected area, press either All-on or Part-on to arm the area.
-
Command 80 may be used to arm all areas.
-
Command 81 may be used to disarm all areas.
Note: Commands 80 and/or 81 must be enabled by an individual with assigned authorization to perform the function.
Use Command 50 to move to another area and arm:
-
Press [CMD] [5][0] and enter a valid code if required.
-
The keypad will scroll through all available areas. Press the desired area number to move to the area.
-
Press All-On or Part-On to arm the selected area. Pressing and holding [CMD] will exit the Command 50 feature returning the keypad to its “home” area.
Use Command 80 to arm All Areas:
-
Press [CMD] [8][0] and enter a valid code if required.
-
Hold down the All On key for 2 sec and it forces all areas to All On.
Use Command 81 to disarm All Areas:
-
Press [CMD] [8][1] and enter a valid code if required.
-
The keypad will indicate all areas are off.