In the D4412/D6412 panel program, access Point Parameters and Global Point Configuration and go to Bypass / Force Bypass Report Routing, and select the required selection; see below:
-
No Reports, No Events to Log/Printer
-
Reports to Destination 1, Events to Log/Printer
-
Reports to Destination 2, Events to Log/Printer
-
Reports to Destination 1 & 2, Events to Log/Printer
-
Reports to Destination 2 only on Destination 1 Comm Fail Event, Events to Log/Printer
-
No Reports, Events to Log/Printer
Default: Reports to Destination 1, Events to Log/Printer