Dip switches 1 and 2 select sensitivity settings:
4 pulse counts is the recommended setting for locations where an intruder is expected to cover a sizable portion of the protection area. The detector tolerates harsh environments at this setting.
3 pulse counts is for locations where normal environmental transients are expected.
2 pulse counts is the normal setting for areas where thermal and illumination transients are minimal.
1 pulse count is for fast response to intruder signals. It is for use in quiet environments where thermal and illumination transients are not anticipated.
-
Pulse Counts Switch 1 Switch 2
-
1 OFF OFF
-
2 ON OFF
-
3 OFF ON
-
4 ON ON
Detection Range Adjustment:
-
Used to fine tune sensitivity. Adjust for lowest sensitivity that provides good catch performance.