NOTE: After completing the below steps, select SAVE & EXIT before exiting TeraTerm or all changes are lost.
-
Set the B450 switch address to 0.
-
Open TeraTerm.
-
The New connection dialogue opens.
-
Select Serial and the port configured for the B450 and press OK.
-
Press the ENTER key and the display reads [Enter Passcode]. Enter the default Log-in password: B450.
-
Select 3 > Basic Configuration
-
Select 7 > GSM/GPRS Config
-
Select 1 > Network Access Point Name (APN)
-
Enter the correct APN for the type of cell card to be used: B444 or B444-V (Verizon): [eaaa.bosch.vzwentp]. B444-A (AT&T): [iotst.aer.net ] B443-ATT (AT&T): [wyless.com.attz] B443-TMO (T-Mobile): [GNE] [B443-ROG (Canada): [wyless.apn]
-
Select SAVE & EXIT before exiting TeraTerm or all changes are lost.
-
Set the B450 address switch as required for use on the connected panel type.
