Breadcrumbs

How to correct the D8112/5505 not sending a Reboot report.


The reboot signal is controlled by the same prompt that controls the low battery reporting. To turn this prompt on:

Using Remote Programming Software:

  1. Receive a copy of the panel program.

  2. In the Main part of the program set Battery Supervision [BatSupv]= Yes. Battery Supervision reports "ZONE 9." Trouble and restoral reports for the battery and D8112 software initialization (disable/restart or RAM "ResetBye" command).

  3. Save the change and send the program back to the panel.

  4. When disconnecting from RPS, be sure to select 'reset-bye'.

Using D5200 programmer:

  1. Receive a copy(RECV/COPY) of to panel into the 8112/5505 handler in the D5200 programmer.

  2. Press the red ENTER GROUP key on the D5200 keyboard to enter 'Main'.

  3. Scroll down to locate Account No./Supervision press the red ENTER GROUP key on the D5200 keyboard.

  4. Press the red down arrow key to scroll down to line item 28 BatSupv.   Press the space bar to toggle the entry to YES and select the white ENTER key.

  5. Press the red SEND(LOAD) key to send the changes to the panel.

  6. Disconnect the D5200 and momentary short terminals 29 and 32 on the control panel to reboot the control panel.  The panel should now send the reboot report .