-
When performing CMD 46 and Cycle, Unlock, or Secure Door, a letter or number will appear in the place-holder for each door. Once entered, place holders for programmed doors will return an indication of the current state of the door.
-
After performing CMD46 followed by Cycle Door, Unlock Door, or Secure Door the keypad will return the following: CYCLE: 1 U -- -- -- -- -- -- , where in this example, Cycle door was performed. Door 1 is locked, door 2 is unlocked, and doors 3 - 8 are not turned on in programming. Below are the other indicators that may also display.
-
F - SDI Failure (data communications have failed)
-
D - Diagnostic mode (D9210B Switch 5 has been turned off, return switch 5 to on)
-
C - Cycling (CMD46 Cycle door has been performed)
-
A - Add (learn mode) Command 56 Add Card, is in use
-
# (1-8) - Door is in the Locked state
-
X - Door is in the Secured state (door will not respond after presenting credentials)
-
U - Door is in the Unlocked state
-
-- - Door has not been turned on in programming