Steps to program a receiver into the EN4204R Echo Stream stand-alone receiver.
-
Open the receiver housing.
-
Connect the power cabling.
-
Set the frequency band.
-
Press the Advance button to select the first transmitter point to program
-
Press the Program button to begin programming the point.
-
Use the Advance button to choose a supervision window; press Program to complete and advance to the output option.
-
Use the Advance button to select the output number; press Program to complete and advance to the output type option.
-
Use the Advance button to select the output type. If programming the EN4204 press Program to complete and advance to the switch type option; if programming the EN4204R, press Program to complete and skip to step 10.
-
Use the Advance button to choose between normally open and normally closed; press Program to complete programming.
-
If you wish to register a transmitter to the point you’ve just programmed, press the transmitter’s Reset button; otherwise, press Program to save programming changes without registering a transmitter.
-
Press Advance to choose the next transmitter point to program.