Place a jumper on the reset pin of the panel and connect other end to ground.
-
-
Turn all DIP switches on command center to off position.
-
Using a D5200 programmer connect to D636A keypad.
-
On the D5200, scroll to the 636 product handler and press "enter group".
-
If there is no saved record for the D636A, leave the cursur flashing on "new record", otherwise scroll to the saved record and leave the cursur flashing on it.
-
On the D636A, press and hold down the 4 and 6 key together and turn switch 1 to the on position.
-
Keypad will display Program Mode. Release keys 4 and 6.
-
On the D5200, press "RECV/COPY".
-
After "receive sucsessful" is diplayed, programming of text may be performed.
-
When done, press "SEND/LOAD", on the D5200, to send changes to the D636A.
-
This record may be saved and sent to each keypad on the system.
-